Inner Housing Assembly - Toro ProForce Debris Service Manual

PRELIMINARY – For Toro Distributor and Toro Company use only.

Inner Housing Assembly

RIGHT
FRONT
Loctite #242
50 to 60 ft−lb
(68 to 81 N−m)
4
3
2
1
1. Inlet bell
2. Retaining ring
3. Wave washer
4. Front cap
5. Nut (LH thread)
6. Spacer
7. Rotor assembly
8. Washer
NOTE: The rotor shaft and bearings can be serviced
without removing inner housing from machine (see Ro-
tor Shaft in this section). For replacement of the inner
housing, stator vanes (item 10) or outer housing (item
12), the following procedure is necessary.
Blower Assembly
9
8
7
6
5
14
9. Woodruff key
10. Stator vane (24 used)
11. Carriage screw (2 used)
12. Outer housing
13. Flange head screw (24 used)
14. Cap screw (8 used)
15. Flange head screw (8 used)
16. Nozzle pulley
10 to 20 in−lb
(1.2 to 2.2 N−m)
13
12
11
10
23
Figure 8
Page 5 − 10
90 to 100 in−lb
(10.2 to 11.2 N−m)
15
24
19
20
21
22
17. Cap screw (2 used per guide)
18. Nozzle guide (4 used)
19. Flange nut (16 used)
20. Fan mount (2 used)
21. Carriage screw (2 used)
22. Flange nut (4 used)
23. Inner housing assembly
24. Spacer (2 used per guide)
ProForce Debris Blower
17
18
16