General Information; Operator's Manual; Securing Proforce Debris Blower To Tow Vehicle; Electrical Power - Toro ProForce Debris Service Manual

PRELIMINARY – For Toro Distributor and Toro Company use only.

General Information

Operator's Manual

The Operator's Manual provides information regarding
the operation, general maintenance and maintenance
intervals for your ProForce Debris Blower. Refer to the
Operator's Manual for additional information when ser-
vicing the machine.

Securing ProForce Debris Blower to Tow Vehicle

While operating or servicing the ProForce blower, make
sure that hitch pin is properly positioned in tow vehicle
hitch and blower tongue. Hitch pin should be secured
with hairpin clip (Fig. 1).

Electrical Power

Electrical power to ProForce Debris Blower compo-
nents is controlled by the Remote Control Module. To
make sure that machine operation does not occur unex-
pectedly, disconnect the negative battery cable from the
battery before performing any machine service.
Reattach the disconnected negative battery cable as
the last step in any repair. Secure cable with flange nut.
Torque nut from from 10 to 15 ft−lb (14 to 20 N−m).
ProForce Debris Blower
2
1
1. Tow vehicle hitch
2. Hitch pin
Page 6 − 3
3
Figure 1
3. Hairpin clip
Chassis