Assembling Procedure - HTC Neon Service Manual

Doc. Title

2.2 Assembling procedure

HTC CONFIDENTIAL
HTC Corporation
.
Neon Service Manual
Doc. No. DOC- 00036367
Issued Date 1/12/2007
Revised Date 11/19/2008
Page
Peel off the film on inner side of Touch
Panel and check if any stain exists. Then
assemble the LCD into bezel.
Warning: Please apply air gun to clean the
LCM & casing surface in CLEAN
ENVIRONMENT , and ensure no dust or
particle inside before assemble into bezel.
Assemble the Receiver into receiver slot.
Assemble the NAVI key into bezel.
1. Assemble the Rigid-Flex Board and
MIC rubber.
2. Fasten the screw on the Rigid-Flex
Board.
SCREW: 72H00934-00M
(M1.6*2) (Q'TY:1)
[NOTE]
PLEASE SET UP THE TORQUE OF
ELECTRICAL SCREW
(Torque) : 0.6+ 0.1 kg-cm
SM-TP002-0706
REV.
A06
27 of 88