Additional options
Factory default settings
If you have altered any settings from
the factory default, you can reset them
back to the factory default settings as
follows:
^ Open the door.
^ Switch the dishwasher off with the Off
button V.
^ Press the programme selector button
in and, whilst holding it in, switch
the dishwasher on using the On
button U .
Keep the programme selector button
pressed in for at least four seconds
until the lower-right hand indicator
light comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the programme selector button
briefly 12 times.
The "Inlet/Drain" indicator light will give
one long flash and two brief flashes at
intervals.
36
The upper right-hand indicator shows
whether a setting other than the factory
default setting has been set.
– If the upper right-hand indicator is
flashing:
All settings are factory default
settings.
– If the upper right-hand indicator is
not lit up:
At least one setting has been altered
from the factory default setting.
^ If you want to reset the factory default
settings, press the programme
selector button for at least one
second until the "Inlet/Drain" indicator
light comes on.
^ Press the programme selector button
briefly.
The setting is now stored in memory.
^ Switch the dishwasher off with the Off
button V.