Antique Brick Kit - Jøtul Direct Vent Gas Fireplace GZ550s Installation And Operation Instructions Manual

Brick Panel Assembly
Install the optional Brick Panels before placing the
Logset. Place the panels in position in the order as
numbered in Fig. 32. No fasteners or tools are
required.
Upper Rear Panel,
220031
Left Side
1
Panel,
220032
Lower Rear Panel,
220030
Figure 35. Panel installation order.
1. Remove the Glass Frame, if you have not already
done so. Open the lower control panel and locate
the two frame latches under the firebox floor. See
Fig. 36. Pull the latch handle forward to disengage
it from the bottom of the glass frame. You can
then pull the frame out and up off of the three
retainer tabs at the top of the firebox opening.
Set the Glass Frame out of the way.
2. Remove the Fettle and Logset. These parts are not
fastened. Simply lift them out of the firebox.
3. Install the Side Panels. Engage the bottom edge
of each side panel between the Logset Base and
the firebox wall and push the panel forward
against the front lip of the firebox opening. See
Fig. 37.
4. Install the Lower Rear Panel. Orient the panel so
that the beveled edge is on top and the mortar
joints align with those on the side panels. Engage
the bottom edge between the rear wall and the
base. Press the panel snugly between the two
side panels. See Fig.38.
5. Install the Upper Rear Panel. This will also be a
snug fit. Set the panel up high and then carefully
lower it to seat its lower edge against the top of
the other rear panel. The side panels will hold it in
place.
4
Right Side
2
Panel,
3
220033
Figure 36. Glass Frame latch locations.
Logset Base
Figure 37. Install the Side Panels.
Bevelled Edge
Figure 38. Install Lower Rear Panel.
Pull Frame Latches to
Release Frame
Side
Panel
19