Hopper - Epson Stylus CX4300 Service Manual

EPSON Stylus CX4300/CX4400/CX5500/CX5600/DX4400/DX4450

4.6.2 Hopper

Part/Unit that should be removed before removing Hopper
Document Cover / ASF Cover / Support Arm / Scanner Unit / Middle Case /
Panel Unit / Printer Mechanism
Removal Procedure
1. Pull open the Bearing slightly (Arrow
2. Remove the Hopper (Arrow ) pulling out the guide pin (B).
3. Remove the Compression Spring 1.94.
Guide Pin (A)
Bearing
Compression Spring 1.94
Figure 4-39. Removing Hopper and Compression Spring 1.94
DISASSEMBLY/ASSEMBLY
), to release the guide pin (A).
Guide Pin (B)
Hopper
Disassembling Printer Mechanism
Before installing the Hopper, be sure to adjust the position of the
LD Roller following the steps below.
1. Unlock the Carriage Lock. (See
2. Move the CR Unit to the center of the printer.
3. Adjust the position of LD Roller turning the EJ Roller clockwise.
LD Roller position: the flat part facing inward.
•
Paper Back Lever position: inner most.
•
Flat part of LD Roller
Figure 4-40. Installing Hopper and Compression Spring 1.94
After replacing the Hopper, perform the following adjustment
A D J U S T M E N T
R E Q U I R E D
(T.B.D.). (Refer to Chapter 5
1. "TOP Margin Adjustment"
2. "PF Band Adjustment"
Revision A
"4.6.1 Printhead (p75)")
Inward
Paper Back Lever
EJ Roller
" ADJUSTMENT (p100)")
78