Epson Stylus CX4300 Service Manual page 40

EPSON Stylus CX4300/CX4400/CX5500/CX5600/DX4400/DX4450
Occurrence
timing Detailed phenomenon
CR position
The LD Roller cannot pick up paper
• Operation
although the LD Roller attempt to rotate
• –
correctly.
The Hopper does not operate during the
• Operation
paper loading sequence although the LD
Roller rotates to load paper from the
• –
ASF Unit.
TROUBLESHOOTING
Table 3-9. Check point for paper out error according to each phenomenon
Defective
unit/part name
1. Check if any paper dust is not adhered to the surface of
the LD Roller.
LD Roller
1. Check if the Hopper operates correctly in the paper
loading sequence.
Hopper
Troubleshooting
Check point
LD Roller
Hopper
Compression Spring
2.51
Revision A
Remedy
1. Set a cleaning sheet in the ASF Unit up side
down. Then holding the top edge, try to load
the paper from the Printer driver. The micro
pearl on the LD Roller surface is removed. To
remove severe smear, staple a cloth
moistened with alcohol to a post card and
clean the roller in the same manner.
(Use a post card for
Non-adhesive Area
the base sheet)
CL Sheet
Adhesive Area
Staplers
This side down
Cloth moistened
with alcohol
*If the problem is not solved, replace the
LD Roller with new one.
1. Reassemble the Compression Spring 2.51
between the ASF Frame and the Hopper.
40