Epson Stylus CX4300 Service Manual page 35

EPSON Stylus CX4300/CX4400/CX5500/CX5600/DX4400/DX4450
Printer Status Replace Ink Cartridge or No Ink Cartridge
Power
Ink
Paper
Status monitor 3
message
This error is detected when;
• The ink consumption amount reaches
100%.
• The ink cartridge is defective.
Fault
Note :
Occurrence
The slight amount of the ink is remaining in the
Cause
I/C even if the Replace Ink Cartridge error is
detected. This is to prevent the Print Head
nozzle from the printing operation without
firing the ink.
Table 3-10, "Check point for no ink
cartridge/CSIC error/incorrect ink
Reference Page
cartridge according to each
phenomenon," on page 43
Note : "–" : No change
TROUBLESHOOTING
Table 3-4. Error Indications and Fault Occurrence Causes
CSIC Error
—
On
—
This error is detected when data from
CSIC cannot be read normally or when
data cannot be written to CSIC.
Table 3-10, "Check point for no ink
cartridge/CSIC error/incorrect ink
cartridge according to each
phenomenon," on page 43
Error Indications and Fault Occurrence Causes
Incorrect I/C
—
On
—
This error is detected when;
• An unsupported ink cartridge has been
installed.
• An ink cartridge with a different
destination has been installed.
Table 3-10, "Check point for no ink
cartridge/CSIC error/incorrect ink
cartridge according to each
phenomenon," on page 43
—
On
—
This error is detected when the PE Sensor
cannot properly detect the paper bottom
edge during feeding of paper.
Table 3-11, "Check point for paper jam
error according to each phenomenon," on
page 44
Revision A
Paper Jam
—
—
On
35