American Dynamics Illustra Flex Series User Manual page 41

3.2.4.2 WIFI
When "WIFI" enabled, the unit automatically search wireless networks (as below figure) for users to select
and join.

Site search list: Survey the local area for available wireless network. The user should select local area
network from the search list.

WIFI setting

Mode: select ad hoc or infrastructure

ad hoc(device to device): Select this when connecting to a computer directly. With this setting
specify a wireless channel. A wireless access points (AP) are not used. When set ad hoc
mode, the user must to select a specific SSID (cube-xxx) for networking. After WIFI
networking, the WIFI IP camera default address is 192.168.1.30.
Note With ad hoc mode, you can't select security of Public, WPA, WPA2, or None.

Infrastructure: Select this when connecting to a computer via an access point (AP) or wireless
router. To join the WLAN, the AP and all wireless clients must be configured to use the same
SSID.

SSID: Service Set Identifier (SSID) is a network name used to be identified the wireless signal
emitted from a wireless access point. The SSID listed here should be the one users selected in the
above figure. The field space is up to 30 alphanumeric characters, and the name must exactly the
same as that used in the wireless access point. Otherwise, no connection will be established.
F 3-35 A
IGURE VAILABLE
41
WIFI N D
ETWORK IAGRAM
Illustra Flex Series 1MP Wireless Cube