Superior TF18NE Installation And Operation Instructions Manual page 17

2. Place the middle log (#2) in front of the U-
burner and against the edges of the plate
as shown in Figure 23.
2
Figure 23 - Installing Log # 2
3. Place the front left log (#3) onto the base
assembly between the middle log (#2) and
the grate fingers. The back of the front left
log (#3) will rest against the front of the
middle log (#2). The notch at the end of
the front left log (#3) will fit around the grate
bar. See Figure 24.
3
Figure 24 - Installing Log # 3
4. Place the front right log (#4) onto the base
assembly between the middle log (#2) and
the grate. The back of the front right log
(#4) will rest against the front of the middle
log (#2). The notch in the end of the front
right log (#4) will fit around the grate bar.
See Figure 25.
5. Place the left back top log (#5) on top of
the rear log (#1). Match the rectangular peg
on top of the left side of the rear log (#1)
with the rectangular hole on the bottom of
the left back top log (#5). Match the metal
126818-01A
INSTALLATION
Continued
www.SuperiorFireplaces.US.com
pin on the top of the rear log (#1) with the
round hole in the bottom of the left back top
log (#5). See Figure 26.
Figure 25 - Installing Log # 4
5
Rectangular
Peg
Figure 26 - Installing Log # 5
6. Place the left top forked log (#6) on the top
of the middle log (#2). Match the rectangu-
lar projection on top of the middle log (#2)
with the rectangular hole on the bottom of
the left top forked log (#6). Match the metal
pin on the top of the middle log (#2) with
the round hold in the bottom of the left top
forked log (#6)See Figure 27, page 22.
7. Place the right rear chunk log (#7) on top
of the middle log (#2) and rear log (#1) as
shown in Figure 28, page 18. Match the
round peg on the top of the rear log (#1)
with the round hole on the bottom of the
right rear chunk (#7) log and square peg
on the top of the middle log (#2) with the
square hole on the bottom of the right rear
chunk log (#7).
4
Metal
Pin
17