Location And Function Of Parts And Operation; Front/Top/Bottom; Using A Tripod - Sony XCL-5005CR Technical Manual

Location and Function of Parts and Operation

Front/Top/Bottom

a Lens mount (C-mount)
Attach any C-mount lens or other optical equipment.
Note
The lens must not project more than 10 mm (13/32 inch)
from the lens mount.
When you use the camera with the lens attached, the
resolution of the image output from the camera may
differ according to the performance of the lens. Note it
when you select a lens.
The performance of a lens may change according to the
aperture level.
If the resolution is not enough, adjust the aperture level.
b Guide holes (Top)
c Reference holes (bottom)
These precision screw holes are for locking the camera
module. Locking the camera module into these holes
secures the optical axis alignment.
You can install the camera on a tripod. To install on
a tripod, you will need to install a tripod adaptor
VCT-ST70I to the camera on the reference holes
c.
Note
Refer to XCL-5005CR/5005 Demensions in page 55 for
about the position/size of the Guide hole and the
Reference hole.
a Lens mount (C-mount)
b
Guide holes (Top)
c
Reference holes (bottom)

Using a tripod

To use the tripod, install the tripod adaptor VCT-ST70I
(not supplied) on the camera module.
Use a tripod screw with a protrusion (4) extending from
the installation surface, as follows, and tighten it, using
a screwdriver. Be sure that the protrusion does not
exceed 5.5 mm (0.2 in.) in length.
ISO standard 4: Length 4 to 5 mm
ASA standard 4: Length 0.16 to 0.20
Note
If you install a tripod adapter (not supplied), use the
screws provided.
inches
Location and Function of Parts and Operation
7