Using Homelink; Reprogramming A Single Homelink Button; Security - Dodge Ram 2010 Owner's Manual

150 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
successfully accepted the frequency signal. The EVIC
display will change from "CHANNEL # TRAINING" to
"CHANNEL # TRAINED."
If you unplugged the device for training, plug it back in
at this time.
Then proceed with Step 4 under "Programming
HomeLink " earlier in this section.

Using HomeLink

To operate, press and release the programmed HomeLink
button. Activation will now occur for the trained device
(i.e., garage door opener, gate operator, security system,
entry door lock, home/office lighting, etc.,). The handheld
transmitter of the device may also be used at any time.

Reprogramming A Single HomeLink Button

To reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink button for
20 seconds until the EVIC display states "CHANNEL #
TRAINING." Do not release the button.
3. Without releasing the button, proceed with Program-
ming HomeLink Step 2 and follow all remaining steps.

Security

It is advised to erase all channels before you sell or turn
in your vehicle.
To do this, press and hold the two outside buttons for
20 seconds until the EVIC message states "CHANNELS
CLEARED." Note that all channels will be erased. Indi-
vidual channels cannot be erased.
The HomeLink Universal Transceiver is disabled when
the Vehicle Security Alarm is active.