Table of Contents
Advertisement
Auto Door Lock
• To have the doors lock automatically when the vehicle's speed exceeds 15 mph
(24 km/h):
• Enter your vehicle and close all the doors.
• Cycle the ignition switch between LOCK and ON and then back to LOCK four
times, ending up in the LOCK position (do not start the engine).
• Press the power door LOCK switch to lock the doors. A single chime will indicate
that programming is complete.
Sound Horn With Lock
• To turn the horn chirp on or off when the doors are locked:
• Press the LOCK button for at least 4 seconds, but no longer than 10 seconds.
Then, press the PANIC button while still holding the LOCK button.
• Release both buttons at the same time.
Flashing Lights With Lock
• The turn signal lights flashing, when the doors are locked or unlocked, feature can
be turned on or off. To turn this feature on or off:
• Press and hold the UNLOCK button for at least 4 seconds, but no longer than
10 seconds. Then, press and hold the LOCK button while still holding the
UNLOCK button.
• Release both buttons at the same time.
UNIVERSAL GARAGE DOOR OPENER
®
(HomeLink
)
• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) from the HomeLink
while keeping the indicator light in view.
• Simultaneously, press and hold both the chosen HomeLink
hand-held transmitter button until the HomeLink
from a slow to a rapidly blinking light, then release both the HomeLink
hand-held transmitter buttons. This may take up to 30 seconds, or longer in rare
cases.
ELECTRONICS
®
Programming HomeLink
Begin Programming
®
• The HomeLink
buttons are located in
the overhead console.
• Erase all channels before you begin
programming by holding the two
outside buttons for up to 20 seconds
until the red indicator flashes.
• Park your vehicle outside of the garage
and turn the ignition switch to the
ON/RUN position.
®
button and the
®
indicator flash rate changes
®
buttons
®
and the
45
Advertisement
Table of Contents
