Headlight Delay - Dodge Ram 2010 Owner's Manual

To Activate
1. To enable the Automatic High Beams, refer to
Customer-Programmable Features (SETUP) under Elec-
tronic Vehicle Information Center (EVIC) — if equipped
in Section 4 for information on programming.
2. Turn the headlight switch to the AUTO headlight
position.
3. Push the multifunction lever away from you (toward
front of vehicle) to engage the high beam mode.
NOTE: This system will not activate until the vehicle is
at or above 20 mph (32 km/h).
To Deactivate
1. Pull back on the multifunction lever to manually
deactivate the system (normal operation of low beams).
2. Push back on the multifunction lever once again to
reactivate the system.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 117
NOTE: Broken, muddy, or obstructed headlights and
taillights of vehicles in the field of view will cause
headlights to remain on longer (closer to the vehicle).
Also, dirt, film and other obstructions (sticker, toll box,
etc.) on the windshield or camera lens will cause the
system to function improperly.

Headlight Delay

To aid in your exit, your vehicle is equipped with a
headlight delay that will leave the headlights on for
approximately 90 seconds. This delay is initiated when
the ignition is turned OFF while the headlight switch is
on, and then the headlight switch is cycled off. Headlight
delay can be cancelled by either turning the headlight
switch on then off, or by turning the ignition ON.
The headlight delay time is programmable on vehicles
equipped with an Electronic Vehicle Information Center
(EVIC). Refer to "Customer-Programmable Features
(SETUP)" under "Electronic Vehicle Information Center
(EVIC)" in Section 4 for further information.
3