Delta 22-580 Instruction Manual page 9

LOWERING THE EXTENSION TABLES
The infeed and outfeed table extensions (A) Fig. 3 are
shipped in the "UP" position on the machine. Lower
both table extensions (A) to the "DOWN" position
(Fig. 3). To check and adjust the top surface of the table
extensions (A) level with the planer table, refer to the
section of this manual entitled "LEVELING TABLE
EXTENSIONS."
CUTTERHEAD LOCK HANDLE
Use the supplied wrench to attach the cutterhead lock handle (A) Figs. 3 & 4, to the shaft (B) with the M6-20mm hex
socket-head screw (C) Fig. 4.
B
Fig. 4
CUTTERHEAD ADJUSTMENT HANDLE
1. Attach the cutterhead adjustment handle (A) Fig. 6 to the shaft (B), making certain that the flat on the shaft is
engaged with the flat in the handle.
2. Fasten the cutterhead adjustment handle (A) Fig. 7 to the shaft using the M5 x 16mm hex socket-head screw (C)
with the hex end of the supplied cutterhead wrench.
3. Rotate handle (A) to the operating position as shown in Fig. 8.
B
Fig. 6
A
C
A
A
Fig. 3
C
A
Fig. 7
9
A
A
Fig. 5
A
Fig. 8