Replacement Procedure; Replacement Of The Fax Kit For The Bizhub C450; Removal Of The Fk-502 (In The Case Of The Bizhub C450) - Konica Minolta FK-502 Service Manual

FK-502 Service Manual Ver.1.0

6 REPLACEMENT PROCEDURE

6.1.Replacement of the fax kit for the bizhub C450

6.1.1

Removal of the FK-502 (in the case of the bizhub C450)

In order to replace the FK-502, remove the FK-502 in the following order.
NOTE Be sure to check to see if the main power switch is turned off.
The board may be damaged due to static electricity. Be sure to take an appropriate measure
against static electricity before conducting the operations.
Replacement of the fax kit for the bizhub C450
1. Turn off the main power switch and the power switch
of the main body, and then unplug the power cord
from the power outlet.
2. Remove the connector provided on the right side of
the main body.
3. Open the right door and remove the rear right cover. (4
screws)
4. Remove the Telephone line cable that is connected.
5. Pull out the FK-502 board from the main body. (2 hinge
screws)
NOTE
• When pulling out the FK-502 board, be sure to
hold the 2 hinge screws provided at the upper
and lower sections and pull them out to this
side.
• When reinstalling the FK-502 board, be sure
to insert it with the board set to the groove.
• Reinstall the above parts following the
removal steps in reverse.
6-1