BASIC SPECIFICATIONS
(11)
Resolution conversion
Scanner
At Sending
inch
Communication
mm
At Receiving
inch
1.1.2
Scanning Section
(1)
Scanning method ......................................... Platen documents
(2)
Scanning resolution ...................................... Normal
(3)
Mixed original .............................................. Possible to mix documents of different sizes.
(4)
Density selection........................................... Selection by using the [Density] key. [Lighter] / [Darker]
(5)
Maximum scanning document width ............ 297 mm (A3 width) both for ADF and Platen
(6)
Maximum scanning document length ........... 432mm (A3 length) / 17 inches (double letter) in the
(7)
Effective scanning range ............................... Compliant to the copier standard
1-2
Density Conversion
→
inch
mm
Density Conversion
→
mm
inch
→
inch
inch
•
Impossible to scan book documents (book mode)
ADF book documents
•
Scanning mode: One sided, Two sided and
Cover+2sided
•
Possible to scan the ADF mixed size documents.
Fine
Super fine
Ultra Super fine600 x 600 dpi
•
Selection by using the [Resolution] key.
•
You can not change settings on each page.
•
After rotation of images, sizes are changed by
EOM every time the length of the scan line is
changed at sending.
•
Possible to mix sizes (A and B).
/ [Std.]
•
You can not change settings on each page.
regular mode
When a document is smaller than the effective scan-
ning area, the area outside the document is erased.
•
ADF scanning:
•
Platen scanning: left, right and head Mask of 2mm
FK-502 Service Manual Ver.1.0
Communication
mm / inch (600 dpi only)
Print
inch
inch
8 x 3.85 lines/mm
8 x 7.7 lines/mm
16 x 15.4 lines /mm
left, right, head and bottom
Mask of 3mm each (0 to 5mm)
each (fixed)