5310 Ip Conference Unit; Accessing/Exiting The Conference Controller Application - Mitel 5000 CP Phone User Manual

5310 IP Conference Unit

The optional 5310 IP Conference Unit (shown below) can be connected to the 5224, 5324,
5330, 5340, and 5360 IP phones to provide full-duplex, advanced IP conferencing.
If you have a 5330, 5340, or 5360 IP phone equipped with a 5310 Conference Unit, you can
use the Conference Controller application on your phone to turn the Conference Unit on or off,
to adjust the volume, or to put the Conference Unit into Presentation mode.
If you have a 5324 phone equipped with a 5310 Conference Unit, use the buttons on the phone
or on the optional remote control mouse to control the Conference Unit.
If you have a 5224 phone equipped with a 5310 Conference Unit, use the Side Control Unit to
control the Conference Unit.
Installation instructions are included with the unit.
Mitel 5310 IP Conference Unit
For information about placing conference calls and adding parties to the conference, refer to the
Placing Conference Calls section in the appropriate user guide.

Accessing/Exiting the Conference Controller Application

If you have a 5330/40/60 phone, you must first access the Conference Controller application to
use the Conference Unit.
NOTE
To access the Conference Controller application:
1.
2.
To exit the Conference Controller application:
®
Mitel 5000 CP Phone User Guide Supplement for v4.0, May 2010
The Conference Controller application is not available on the 5224 and 5324 phones.
Press (Applications).
Press Conference Unit.
Press Close in the Conference Controller application.
5310 IP Conference Unit
5310 IP Conference Unit
Page 5