Polaris TX Starfire Owner's Manual page 57

THREE CYLINDER IGNITION (Con't.)
case that the engine runs with two cylinders out of three
due to troubles of engine itself, either the high tension
lead of the idle cylinder will short circuit or with the rest
two cylinders engine will operate normally if all the plug
caps are kept fixed.
2.5 Ignition Coil
The ignition coils have such an outer appearance as shown
in the drawing; the coil has closed iron core; wound coils
are impregnated by epoxy resin and molded tightly by
thermo plasticity resin. These three coils are connected
by their primary coils through couplers in series.
3. Mounting and Dismounting of Generator
3.1 Mounting
(1) To mount the stator on an engine, confirm that any
dust and/or chips are not left on the surfaces to be set
together, and give care that the coils are not damaged.
Next, mount the stator on the engine and fix it firmly
by three screws. When inserting screws, avoid to force
leads and/or coils shift or slide aside by using a driver
and etc.
(2) In mounting the rotor, remove anti-rust oil coated
on its surfaces and clean the shaft with a dry cloth. Next
put on the rotor to the engine shaft and screw it firmly
with torque of 60ft. lbs.
(3) Mounting of COl unit and ignition coil
COl unit and ignition coil should be mounted at the well
ventilated places with environmental temperature below
60°C.
55