Polaris TX Starfire Owner's Manual page 13

BRAKES (Can't.)
Bleeding the Hydraulic Brake System
To bleed the system, the following method should be followed.
1. Remove master cylinder reservoir cover and fill to top lip
of reservoir. Refer to Fig. 1, Item A.
2. Slip rubber tube over ball of top bleeder valve to direct
fluid away from painted surfaces. Refer to Fig. 2, Item A.
3. Squeeze brake lever (slowly) a full stroke and hold; to
release air through tube, unscrew top bleeder valve 3/4
turn. Close bleeder valve, then release brake lever. Repeat
above procedure until fluid flows from bleeder valve in a
solid stream that is free of air. Check master cylinder res-
ervoir periodically to make sure that it contains fluid.
Fig.
1
Fig. 2
11