Polaris TX Starfire Owner's Manual page 48

KOKUSAN-DENKI BREAKERLESS FLYWHEEL
MAGNETO TYPE GK 352 (Con't.)
5.3 Ignition Coil
Wipe off dust and oil with care. Check breaking down of
primary coil and secondary coil by using an ohm tester.
Normal primary resistance is 0.36 ohms and secondary
resistance is 1100 ohms.
5.4 CDI Unit
Clean with care and check the following points with tester:
(1) Resistance between case and lead wire (white) should
be oo .
(2) When connected lead wire (white) to (+) terminal of
tester and lead wire (brown) to (-) terminal electricity
must flow.
(3) When connected in contrastwith the above electricity
must not flow.
(4) Next check lead wire (black) and lead wire (white)
by (+) {-) of tester. The resistance must be 200M ohms
or more.
(5) When sensitivity of the tester is raised to the utmost
degree connect lead wire (black) to (+) and lead wire
(orange) to (-). In this case dial of the tester must swing
once and must return to its place.
NOTE: The tester to be used for the above mentioned
must be for 3V.
46