Handlebar Adjustment - Triumph Tiger Explorer Owner's Handbook Manual

Handlebar Adjustment

The handlebars are adjustable for reach by
approximately 0.8 in (20 mm).
Warning
It is recommended to have handlebar
adjustments carried out by a trained
technician of an authorized Triumph
dealer. Handlebar adjustments carried out
by a technician who is not of an authorized
Triumph dealer may affect the handling,
stability or other aspects
motorcycle's operation which may result in
loss of motorcycle control and an accident.
Warning
Before starting work,
motorcycle is stabilized and adequately
supported. This will help prevent injury to
the operator or damage to the motorcycle.
Note:
• This procedure
handlebars are in the standard
position, as delivered from the
factory. If the handlebars have
already been
described below, the bolt positions
will be reversed.
To adjust the handlebars, loosen and remove
the handlebar rear (8 mm threaded) clamp
bolts, and then the front (10 mm threaded)
clamp and riser bolts.
of the
chiv_1
1. 10 mm bolts
2. 8 mm bolts
ensure the
Lift the handlebars out of the handlebar risers
and support with the aid of an assistant.
Rotate both risers through 180° and align the
bolt holes.
Reposition the handlebars to the risers.
assumes the
Re-install the upper clamps, and secure with
the two 10 mm threaded bolts in the rear
bolt positions. Do not fully tighten the bolts at
this stage.
adjusted as
General Information
2
1
65