Clock Adjustment - Triumph Tiger Explorer Owner's Handbook Manual

Models without TPMS: Press the set
button and do not touch the scroll or set
buttons again until ºC or ºF is visible. Press
and release the scroll button until the desired
temperature unit is displayed. Then press the
set button and wait until UnitS is visible in the
display screen. When UnitS is visible in the
display screen, press and release the home
button and the odometer in the trip 1 menu
will be visible in the display screen.
Models with TPMS: Press the set button
and do not touch the scroll or set buttons
again until PSI or bAr is displayed. Press and
release the scroll button until the desired tire
pressure units are visible. Press the set button
and wait until ºC or ºF is visible. Press and
release the scroll button until the desired
temperature unit is displayed. Then press the
set button and wait until UnitS is displayed,
then press the home button and the
odometer in the trip 1 menu will be visible in
the display screen.
General Information

Clock Adjustment

To reset the clock; with the motorcycle
stationary and in neutral turn the ignition to
the ON position. Press and release the set
button on the left hand switch cube until
'SEtUP' is visible in the display screen. Press
and release the scroll button until t-SEt is
visible.
Press the set button again and either 24 Hr
or 12 Hr clock will be shown. Press the scroll
button to select the desired clock display and
then press the set button. The hour display
will start to flash and the word Hour is visible
in the display screen.
Note:
• The hour/minute
increase when pressing the up part
of the scroll button or decrease
when pressing the down part of
the button.
To reset the hour display, ensure that the
hour display is still flashing and the word
Hour is visible. Press the scroll button to
change the setting. Each individual button
press will change the setting by one digit. If
the button is held, the
continuously scroll through in single digit
increments.
display will
display will
31