Figure 38: Upnp Screen - Quasar CF-4251 User And Installation Manual

Quasar CF-4251 User and Installation Guide
Note:
You may have to consult with your System Administrator to activate this function.
Traps for SNMP v1/v2/v3
Traps are used by the camera to send messages to a management system for important events or
status changes.

Enable traps – Check this box to activate trap reporting.
Trap address – Enter the IP address of the management server.
o
Trap community – Enter the community to use when sending a trap message to the
o
management system. The default value is public.

Trap Option
Warm start – A warm start SNMP trap signifies that the SNMP device, such as the
o
camera, performs a software reload.
Click Save when complete.
7.3.3.4 UPnP
The UPnP page enables the Universal Plug-and-Play protocol on your network devices.
UPnP Setting

Enable UPnP – If UPnP is enabled and a camera is discovered on the LAN, the icon of the
connected camera appears in My Network Places, allowing direct access, as seen below.
38

Figure 38: UPnP Screen