Basic Operation; Turning On The Power; Zoom/ Focusing; Selecting Video Memory - Runco Reflection CL-710 Owner's Operating Manual

Runco CL-710/ CL-710LT User's Manual

4. Basic Operation

Turning on the Power

The Power LED lights orange when power is applied
and the power switch is turned on.
Press and hold the ON key on the remote control
for ONE second to turn on the unit. The POWER
LED will blink orange during warm up period, then
light solid green.
" Searching...." will be displayed on the screen before
the projector identifies the input signal. This message
will remain on the screen until a valid signal is
detected.
If an incompatible input signal exceeds the range of
the projector a "Not supportive timing" message will
be displayed on the screen. This message will remain
on the screen until you change the input signal.

Zoom/ Focusing

Adjust the projection image size you need with the
zoom ring on the lens. To focus the image, rotate the
focus ring on the lens.

Selecting Video Memory

Press M1, M2, M3 buttons to recall settings in the
memory.
Press Default to select the default setting.
18
4. Basic Operation
Zoom out
Focus
Zoom in