Intake Air Heater; Starter; Alternator - Kubota V3600-E3 Shop Manual

V3-E3B SERIES, V3-E3CB SERIES, V3-E3BG SERIES, WSM
(12) Intake Air Heater [V3800DI-T-E3B, V3800DI-T-E3CB, V3800DI-T-E3BG]

(13) Starter

(14) Alternator

Intake Air Heater

1. Remove the inlet hose.
2. Disconnect the lead.
3. Remove the flange (1).
4. Remove the intake air heater (2).
(1) Flange
Disassembling Motor
1. Disconnect the solenoid switch (3).
2. Remove the 2 through screws (9) and the 2 brush holder lock
screws. Take out the rear end frame (13) and the brush holder
(12).
3. Disconnect the armature (10) and the yoke (11). Remove also
the ball (7) from the tip of the armature.
4. Remove the set of packings (8), the 4 planetary gears and
another packing.
5. Take out the shaft assembly. Take note of the position of the
lever.
IMPORTANT
• Before disconnecting the yoke, put tally marks on the yoke
and the front bracket.
• Take note of the positions of the set of packings and the
setup bolt.
• Apply grease to the gears, bearings, shaft's sliding part and
ball.
NOTE
• Do not damage to the brush and commutator.
(When reassembling)
• Apply grease to the parts indicated in the figure.
(1) Gear
(2) Front Bracket
(3) Solenoid Switch
(4) Overrunning Clutch
(5) Internal Gear
(6) Planetary Gear
(7) Ball
Front Bracket
1. Remove the 4 screws (3).
2. Separate the front bracket (1) and the rear bracket (2) from each
other.
IMPORTANT
• Put a tally line on the front bracket and the rear bracket for
reassembling them later.
(1) Front Bracket
(2) Rear Bracket
S-83
DIESEL ENGINE
(2) Intake air heater
W1043265
(8) Set of Packings
(9) Through Bolt
(10) Armature
(11) Yoke
(12) Brush Holder
(13) Rear End Frame
W1074237
(3) Screw
W1074745