V3600-E3Cb, 140.0 Kgf/Cm - Kubota V3600-E3 Shop Manual

V3-E3B SERIES, V3-E3CB SERIES, V3-E3BG SERIES, WSM
Fuel Tightness of Pump Element
1. Remove the solenoid.
2. Remove the injection pipes.
3. Install the injection pump pressure tester to the injection pump.
4. Install the injection nozzle (2) jetted with the proper injection
pressure to the injection pump pressure tester (1). (Refer to the
figure.)
5. Set the speed control lever to the maximum speed position.
6. Run the starter to increase the pressure.
7. If the pressure can not reach the allowable limit, replace the
pump with new one or repair at a Kubota-authorized pump
service shop.
Fuel tightness of Allowable
pump element limit
NOTE
• Never try to disassemble the injection pump assembly. For
repairs, you are strongly requested to contact a Kubota-
authorized pump service shop.
(1) Injection Pump Pressure Tester
(2) Injection Nozzle
(3) Protection Cover for Jetted Fuel
S-30
DIESEL ENGINE
V3600-E3B,
V3600-T-E3B,
13.73 MPa
V3600-E3CB,
140.0 kgf/cm
V3600-T-E3CB,
1991 psi
V3300-E3BG,
V3600-T-E3BG
V3800DI-T-E3B,
V3800DI-T- 18.63 MPa
E3CB, 190.0 kgf/cm
V3800DI-T- 2702 psi
E3BG
[A] V3600-E3B, V3600-T-E3B,
V3600-E3CB, V3600-T-E3CB,
V3300-E3BG, V3600-T-E3BG
[B] V3800DI-T-E3B, V3800DI-T-E3CB,
V3800DI-T-E3BG
2
2
W1017430