Gear Case And Timing Gears - Kubota V3600-E3 Shop Manual

V3-E3B SERIES, V3-E3CB SERIES, V3-E3BG SERIES, WSM

(9) Gear Case and Timing Gears

Gear Case Cover
1. Remove the gear case cover (1).
(When reassembling)
• Confirm that the liquid gasket coating surface is free of water,
dust and oil in order to maintain sealing effect.
• Carefully apply the adhesive evenly. (Refer to the figure on the
left.)
• Be careful not to damage the water pipe (2) and O-ring (4).
NOTE
• When mounting the adhesive-applied parts, take care to fit
them to the mating parts.
• Assemble the adhesive-applied parts within ten minutes.
• Apply a liquid gasket (Three Bond 1217D) to the gear case
cover.
• Use the new O-rings when reassembling.
Gear case cover
mounting screw (7T)
Tightening torque
Gear case cover
mounting screw (10T)
(1) Gear Case Cover
(2) Water Pipe
(3) Liquid Gasket
(4) O-ring
S-72
DIESEL ENGINE
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
33 to 36 N·m
3.3 to 3.7 kgf·m
24 to 26 lbf·ft
[A] V3600-E3B, V3600-T-E3B,
V3800DI-T-E3B, V3300-E3BG,
V3600-T-E3BG, V3800DI-T-E3BG
[B] V3600-E3CB, V3600-T-E3CB,
V3800DI-T-E3CB
W1189218