VIVOTEK
Network Deployment
Setup the Network Camera over the Internet
This section explains how to configure the Network Camera over an Internet
1� If you have external devices such as sensors and alarms, connect them to the general I/O
terminal block�
2� Connect the camera to a switch via Ethernet cable�
3� Connect the supplied power cable from the Network Camera to a power outlet�
There are several ways to set up the Network Camera over the
up the Network Camera behind a
to use
PPPoE�
Internet connection via a router
Before setting up the Network Camera over the Internet, make sure you have a router and follow
the steps below�
1� Connect your Network Camera behind a router, the Internet environment is illustrated below�
Regarding how to obtain your IP address, please refer to Software Installation on page 11 for
details�
Internet
Cable or DSL Modem
8 - User's Manual
3
AV
e e
router�
The second way is to utilize a static
WAN (Wide Area Network )
WAN (Wide Area Network )
Router IP address : from ISP P
Router IP address : from ISP
LAN (Local Area Network)
LAN (Local Area Network)
Router IP address :
Router IP address : 192.168.0.1
1: Power
2: Digital ouput
3: Digital input
4: Ground
1
2
Ethernet Switch
Internet�
The first way is to set
IP address : 192.168.0.3
Subnet mask : 255.255.255.0
Default router : 192.168.0.1
IP address : 192.168.0.2
Subnet mask : 255.255.255.0
Default router : 192.168.0.1
connection�
IP�
The third way is