3. Using a number 2 Phillips screwdriver, loosen the screw securing the chassis foot
to the chassis (
4. Remove the chassis foot.
FIGURE 8-8
8.6.2
Replacing the Chassis Foot
1. Position the chassis foot (
2. Using a number 2 Phillips screwdriver, tighten the screw securing the chassis foot
to the chassis.
3. Position the system unit in the operating position.
4. Power on the system unit.
See Section 6.1 "Powering On the System Unit" on page 6-1.
).
FIGURE 8-8
Removing and Replacing the Chassis Foot
FIGURE 8-8
Chassis foot (4)
Screw (4)
).
Chapter
-19