Exterior Cleaning - U-Line CLR2160 Installation Manual

Inspection
Unwrap and inspect the unit on a flat, level surface
capable of supporting its entire weight.
Removing Protective Coating
(Stainless Steel Units Only)
When inspecting/installing a Stainless Steel unit, the
protective coating covering the unit must be removed
first. Start at a corner of the unit/door and pull back the
protective coating to remove it from the unit/door.
After all the protective coating has been removed from
the unit/door, clean all Stainless Steel surfaces with Claire
Stainless Steel Polish and Cleaner or comparable product
or a mild detergent and warm water solution and soft
cloth. Do NOT use abrasive cleaning agents.
Note: If cleaning with mild detergent and warm water
solution and soft cloth, the unit MUST be treated with
Claire Stainless Steel Polish and Cleaner or comparable
product to prevent discoloration.
www.U-LineService.com
CLR2160/CLRCO2175 Ice Makers

Exterior Cleaning

(As Required)
Black and White Models:
• The door, grille and cabinet may be cleaned with a mild
Stainless Steel Models:
• Stainless steel models can discolor when exposed to
• Keep your stainless steel unit looking new by cleaning
• Do not clean with steel wool pads.
• Do not use cleaners that are not specifically
• If any surface discolors or rusting appears, clean it
• Use of abrasive pads such as Scotchbrite will
• Rust that is allowed to linger can penetrate into the
4
detergent and warm water solution. Do not use
solvent-based or abrasive cleaners. Use a soft sponge
and rinse with clean water. Wipe with a soft, clean
towel to prevent water spotting.
chlorine gas, pool chemicals, salt water or cleaners with
bleach.
with a good quality all-in-one stainless steel cleaner/
polish on a monthly basis. For best results use Claire
Stainless Steel Polish and Cleaner, which can be
purchased from U-Line Corporation. (The part number
is 173348.) Comparable products are acceptable.
Frequent cleaning will remove surface contamination
that could lead to rust. Some installations may require
cleaning on a weekly basis.
intended for stainless steel (this includes glass,
tile and counter cleaners).
quickly with Bon-Ami or Barkeepers Friend Cleanser
and a non-abrasive cloth. Always clean in the direction
of the grain. Always finish this process with Claire
Stainless Steel Polish and Cleaner or comparable
product to prevent further problems.
cause the graining in the stainless to become
blurred.
surface of the stainless steel and complete removal of
the rust may not be possible.
05/2007