Relocating The Shelves (Clrco2175); Installation Troubleshooting - U-Line CLR2160 Installation Manual

Relocating the Shelves (CLRCO2175)

Both the glass shelves in the refrigerator and the inner
door shelves can be moved to accommodate your bottles,
cans and containers.
Glass Shelves on Right-Hand Hinge Units
1. Open door fully, grasp shelf firmly, lift front edge
slightly and pull straight out.
2. Choose new location and slide shelf onto the
appropriate rib.
Glass Shelves on Left-Hand Hinge Units
1. See Figure 51. Pull shelf
out about 6" to clear the
wall's molded protrusion.
2. Tilt right-hand edge of
shelf up.
3. Keeping at this angle and
hugging the right wall,
pull the shelf out.
4. Choose new location and
insert over ribs, tilting
right-hand edge up. Push
in, then lower shelf onto
ribs.
Door Shelves
1. First pull shelf up at a 45°
angle, then straight out
(see Figure 52).
2. Choose new location and
line up on bosses. First
push straight in, then
down at a 45° angle.
www.U-LineService.com
CLR2160/CLRCO2175 Ice Makers
1. Pull Out 6"
3. Pull
2. Tilt
Figure 51
Notch
Boss
Figure 52

Installation Troubleshooting

Q:
Problem
Water is leaking under the unit.
A:
Solution
A water leak under the unit is most likely caused by a bad
connection in the water supply line. Make sure the water
line's brass fitting is screwed tight to its valve and
threaded correctly. Make sure the fill tube's connection to
the water line is also tight. Check drain line to make sure
it has not been disconnected from drain connection on
back of the unit or disconnected from the drain.
Q:
Problem
The door remains open unless it is pushed closed.
A:
Solution
The hinges should be self-closing when the door is open
approximately 8". If this is not the case, make sure the
closers (at the bottom of the hinge pin) are clean, greased
and installed correctly. Also, re-check leveling from front
to back of the unit and readjust if necessary. Make sure
that pivot plate is installed correctly.
Q:
Problem
The custom overlay door was designed to align with the
rest of the cabinet doors, but the unit has crept forward.
A:
Solution
First, make sure that the electrical cord and water supply
line are not obstructing the installation. If they are not,
there is mostly likely not enough room allowed for the
drain connection on the rear of the unit. You may need to
alter the wall behind the unit to accommodate the drain
connection.
22 05/2007