U-Line CLR2160 Installation Manual page 11

2. Create a relief (Figure 19) for pivot plate by cutting
notch in top corner of overlay panel. Refer to Figure
20 for exact specifications.
15/32"
ø 0.177" (#16 Drill)
11/16" Deep
.125"
11/16"
1/4" Ref
3/4" Min Ref
SIDE VIEW
13/32"
Figure 20
Route notch in top corner of overlay panel as shown
(see Top and Side Views). Top of notch is entire depth
of panel, front to back.
Width: 31/32"
Depth: 1/8"
CAUTION
Be careful not to drill too deep! Drilling holes too deep
may destroy your door panel.
3. Drill hole for upper door hinge (top of panel) (see
Figure 20, Top View).
0.177" diameter
(#16 drill) x 11/16" deep
4. Drill hole for lower door hinge (see Figure 20, Bottom
View).
5/16" diameter x 1/4" deep
CAUTION
It is important to ensure that all drilled holes are drilled to
the correct depth in order to avoid splits in the wood
when hardware is installed.
05/2007
CLR2160/CLRCO2175 Ice Makers
TOP VIEW
3/8"
31/32"
Ref
BACK VIEW
3/8"
BOTTOM VIEW
ø 5/16" x 1/4" Deep
Chamfer 1/32" x 45°
ULIN_0401_A
Installation Instructions
Removing Existing Door
1. Remove the door shelves by first pulling shelves up at
a 45° angle, then straight out.
2. Remove top hinge screw pin (Phillips screwdriver).
Remove the door by tilting forward and lifting off the
bottom hinge pin.
3. Pull door gasket out of the groove (top edge of door
only). Start in the middle and pull outward, moving
toward the edge (see Figure 21). This may take some
force.
Figure 21
4. Remove the two screws located on both sides of the
handle.
5. Remove the handle and discard. (This handle will be
replaced with the Overlay Handle included in the Full
Overlay Door Panel Kit. See Figure 22.)
6. Slide the existing door panel out of the doorframe.
Attaching the Full Overlay Panel
1. Place and tape the existing door panel on the back of
the overlay panel (see Figure 23) and drill holes
through both panels according to Figure 24. Remove
tape adjoining the panels and enlarge the six holes in
the steel (black/white vinyl color) panel using a 0.201"
(#7) drill.
2. If a user-supplied cabinet handle will be used, attach its
hardware to the overlay panel at this time.
11
Old Handle
New Handle
Figure 22 ULIN_0403_A
www.U-LineService.com