Installer Setting-Thermistor - LG Single "A" Service Manual

Part 2 Functions & Controls
Installer Setting -Thermistor
j Therefore system will use value that sensed from indoor unit or remote controller
<Thermistor Table>
Temperature sensor location
01 Remote controller
02 Indoor unit
03 2-Thermistor(2TH)
Copyright ©2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
1
2
3
4
5
Operation in remote controller temperature sensor
Operation in indoor unit temperature sensor
Operation in lower temperature after comparing the temperature between the indoor unit
And remote controller
- 38 -
Press button for 4 seconds
to enter the installer setting
mode until timer segment
display "01:01".
Repeat pressing
Function code 04.
Function Code
Ex) Setting Thermistor as '2TH'.
Set Thermistor mode by pressing
button. (01: Remote Controller,
02: Indoor, 03: 2TH)
Press button to save or release.
Press button to exit or
system will automatically exit
after 25 seconds without any
input.
Function
button to select
Thermistor setting
LGE Internal Use Only