Using The Multichannel Dvd Input; Adjusting The Bass & Treble; Displaying Source Information - Onkyo TX-SR705 Instruction Manual

Basic Operations

Using the Multichannel DVD Input

The multichannel DVD input is for connecting a compo-
nent with a 7.1-channel analog audio output, such as a
DVD-Audio or SACD-capable DVD player, or an
MPEG decoder. See page 31 for hookup information.
Press the [RECEIVER] button,
followed by the [MULTI CH] but-
ton.
The MULTI CH indicator appears on
the display.
Audio from the multichannel DVD
input will now be used for the DVD
input source.
Note:
While the multichannel DVD input is selected, the
Speaker Configuration settings on page 77 are ignored,
and signals from the multichannel input are fed to the
speakers as they are.
Adjusting the Bass & Treble
You can adjust the bass and treble for the front speakers,
except when the Direct or Pure Audio listening mode is
selected.
1
Press the [TONE] button repeat-
edly to select either Bass or
Treble.
2
Use the TONE [–]/[+] buttons to
adjust.
■ Bass
You can boost or cut low-frequency sounds output by the
front speakers from –10 dB to +10 dB in 2 dB steps.
■ Treble
You can boost or cut high-frequency sounds output by
the front speakers from –10 dB to +10 dB in 2 dB steps.
Note:
The Bass & Treble settings do not apply to the THX lis-
tening modes.
60
MULTI CH indicator

Displaying Source Information

You can display various information about the current
input source as follows.
Press the [RECEIVER] button,
and then press the [DISPLAY]
button repeatedly to cycle
through the available informa-
tion.
Note:
This procedure can also be performed on the AV
receiver/AV amplifier by using its [DISPLAY] button.
The following information can typically be displayed for
input sources.
Input source &
volume
Signal format*
or sampling
frequency
Input source &
listening mode
* If the input signal is analog, no format information is
displayed. If the input signal is PCM, the sampling fre-
quency is displayed. If the input signal is digital but not
PCM, the signal format is displayed. Information is
displayed for about three seconds, then the previously
displayed information reappears.