Connecting A Cd Player Or Turntable - Onkyo TX-SR705 Instruction Manual

Connecting the AV Receiver/AV Amplifier

Connecting a CD Player or Turntable

■ CD Player or Turntable (MM) with Built-in Phono Preamp
Step 1:
Choose a connection that matches your CD player ( ,
phono preamp.
b
Connect one or
c
the other
Connection b
must be
assigned (see
page 51)
COAXIAL
OUT
• With connection , you can listen to and record audio from the CD player and listen in Zone 2.
a
• To connect the CD player digitally, use connection
Connection AV receiver/AV amplifier
a
DIGITAL COAXIAL IN 2
b
DIGITAL OPTICAL IN 2 (CD)
c
■ Turntable (MM) with no Phono Preamp Built-in
The AV receiver/AV amplifier's PHONO IN is designed
for use with a moving magnet (MM) type cartridge.
Use an analog audio cable to connect the AV
receiver/AV amplifier's PHONO IN L/R jacks to the
audio output on your turntable.
Notes:
• If your turntable has a ground wire, connect it to the
AV receiver/AV amplifier's GND screw. With some
turntables, connecting the ground wire may produce
an audible hum.
If this happens, disconnect it.
• If your turntable has a moving coil (MC) type car-
tridge, you'll need a commercially available MC head
amp or MC transformer. Connect your turntable to the
head amp or transformer, and connect that to the AV
receiver/AV amplifier's PHONO IN L/R jacks.
• You can also use a phono equalizer to connect a turn-
table with an MC-type cartridge. See your phono
equalizer's manual for details.
a
IN 2
(VCR/DVR)
COAXIAL
OPTICAL
IN 2
(CD)
IN
L
R
CD
a
L R
OPTICAL AUDIO
OUT OUT
Signal flow
CD IN L/R
(VCR/DVR)
, or ). Use connection
b c a
CD player
or . (For recording, use
b c
CD or turntable
Analog audio L/R output
Digital coaxial output
Digital optical output
for a turntable with a built-in
IN
L L
R R
AUDIO
CD
OUTPUT
a
Turntable (MM) with
built-in phono preamp
and , or and .)
a b a c
L
R
IN
PHONO
AUDIO
OUTPUT
L
R
39