Log Placement; Glowing Embers - Napoleon GDIZC-N Installation And Operating Instructions Manual

14
4.3

LOG PLACEMENT

FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
PHAZER TM logs and glowing embers exclusive to Napoleon Fireplaces, provide a unique and realistic glowing effect that is
different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.
Log colours may vary. During the initial use of the fi replace, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
A.
Place the rear log (#1) onto the two log supports
and against the air intake pipe.
C.
Fit the centre log (#4) into place behind log #3 and
into the pocket provided on the back log.
4.4

GLOWING EMBERS

Tear the embers into pieces and place along the front
row of ports covering all of the burner area in front of the
logs. Care should be taken to shred the embers into thin,
small irregular pieces as only the exposed edges of the
fi bre hairs will glow. The ember material will only glow
when exposed to direct fl ame; however, care should
be taken to not block the burner ports.
Blocked burner ports can cause an incorrect fl ame
pattern, carbon deposits and delayed ignition.
PHAZER TM logs glow when exposed to direct fl ame. Use only certifi ed "glowing embers" and PHAZER
available from your authorized dealer / distributor.
W415-0223 / G / 06.04.12
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
#1
#4
WARNING
!
#2
B.
Position logs #2 and #3 against the grate posts
and line up the studs located on the burner with the
holes on the bottom of the logs. Keep slightly back
of the front row of ports.
76.1A
#3
GLOWING EMBERS
TM logs