Table of Contents
Advertisement
F. Thermostat and Thermostat Cable Instal-
lation
1. SZLCD Thermostat
Note: Wire colors listed for the three conductor cable
match the wire colors in the harness at the SZLCD control
box. Available wire colors may vary.
FIG. 4
a. Remove the cover from the SZLCD thermo-
stat. Depress tab on bottom of thermostat
and separate it from the base.
b. Insert the previously run three (3) conductor
cable through the hole in the base assembly.
c. Cut back the outer cable shield approximate-
ly 3 inches and strip 1/4" insulation from each
wire.
d. Mount the thermostat level on the wall using
the screws provided.
e. Make the following connections to the ther-
mostat. See FIG 4.
• Red/white wire to the 12V+ terminal
• Black wire to the 12V– terminal
• Orange wire to the "COMMS" terminal
f.
Inspect all connections to make sure they are
tight and not touching any other terminals or
wires.
g. Push the wires back through the base into
the wall. Place cover on the thermostat and
push until an audible click is heard.
G. Placing The Unit On The Roof
Personal injury hazard. This unit weighs ap-
proximately 100 pounds. To prevent back
injury, use a mechanical hoist to place unit
on roof. Failure to obey this warning could
cause severe personal injury.
1. Remove the unit from the carton and discard car-
ton.
2. Place the unit on the roof.
3. Lift and place the unit over the prepared opening
using the gasket on the unit as a guide. See FIG.
5.
FIG. 5
Property damage hazard. Do not slide the
unit. Failure to obey this warning may dam-
age the neoprene gasket attached to the bot-
tom and create a leaky installation.
4. Place the air distribution box kit inside the RV.
This box contains mounting hardware for the unit
and will be used inside the RV.
This completes the outside work. Minor adjustments can
be done from inside the RV if required.
6
Front
Do Not Slide
Hide quick links:
Advertisement
Table of Contents
