Oki 182 Handbook page 21

_ _ _ _ _ _ _ _ _ _ _ CHAPTER 1 SETIING UP
2. Snap the two wire clips onto the plug.
3. Insert the other end of the cable into your computer. You may
also connect it to'another peripheral device, such as a disk
drive, if your equipment is designed for "daisy-chain"
connection.
-
4. Turn on the equipment and try the one-line program shown
below, using the proper print statement for your computer (the
example uses LPRINT). (Make sure you have paper and ribbon
in the printer.)
5. Type: LPRINT "Everything's okay" and then run the program.
6. Your printer should print "Everything's okay" at 10 characters
per inch.
NOTE: If the printer did not print, make sure you entered the program properly. Some
computers require that you assign
a
number to the printer and specify that number in
your print statement; for example OPEN # 3 means the printer is on line # 3 to the
computer.
7. Now try this program (change it, if necessary, to suit your com ­
puter's requirements):
10 LPRINT "EVERYTHING'S OKAY"
20 LPRINT "THIS LINE SHOULD BE SPACED 1/6"; CHR$(34);"
UNDER THE FIRST"
8. The printout should look like this:
,tVERYTHING'S OKAY
TH
I S LI NE SHOULD BE SPACED .11 E." UNDER THE FIRST
13