Oki 182 Handbook page 17

- - - - - - - - - - - CHAPTER 1 SETTING UP
c.
Close the paper release lever.
d. Turn the platen knob away from you to pull the paper
around the platen and behind the column indicator bar.
e. Move the column indicator bar back onto the platen so that
the rollers rest on the paper you just inserted.
-
10. Advance the paper, using the platen knob, until 1 inch of paper
appears above the column indicator bar.
11. Replace the access cover:
a. Insert the three tabs in the edge of the access cover into the
holes on the top front edge of the printer"
b. Lower the access cover onto the printer.
12. Grasp the paper and pull it through the opening in the access
cover. Use the platen knob if you need more paper.
13. Insert the connector end of the power cord into the plug on the
left side of the printer back.
14. Make absolutely certain that the ON/OFF power toggle switch
on the side of the printer is OFF. (A sudden power surge can
damage the printer.)
15. Plug the power cord into a grounded (three-pronged) electrical
outlet.
CAUTION: The printer must be grounded at all times. Do not avoid the grounding plug by using
a
three-to-two prong conversion plug.
-
-
9