Emc Installation Guidelines - Raymarine C-Series Installation Manual

EMC Installation Guidelines

All Raymarine equipment and accessories are designed to the best industry standards for use in
the recreational marine environment.
Their design and manufacture conforms to the appropriate Electromagnetic Compatibility
(EMC) standards, but correct installation is required to ensure that performance is not
compromised. Although every effort has been taken to ensure that they will perform under all
conditions, it is important to understand what factors could affect the operation of the product.
The guidelines given here describe the conditions for optimum EMC performance, but it is
recognized that it may not be possible to meet all of these conditions in all situations. To ensure
the best possible conditions for EMC performance within the constraints imposed by any
location, always ensure the maximum separation possible between different items of electrical
equipment.
For optimum EMC performance, it is recommended that wherever possible:
Raymarine equipment and cables connected to it are:
At least 3 ft. (1 m) from any equipment transmitting or cables carrying radio signals e.g. VHF
radios, cables and antennas. In the case of SSB radios, the distance should be increased to 7 ft.
(2 m).
More than 7 ft. (2 m) from the path of a radar beam. A radar beam can normally be assumed to
spread 20 degrees above and below the radiating element.
The equipment is supplied from a separate battery from that used for engine start. Voltage
drops below 10 V, and starter motor transients, can cause the equipment to reset. This will not
damage the equipment, but may cause the loss of some information and may change the
operating mode.
Raymarine specified cables are used. Cutting and rejoining these cables can compromise EMC
performance and must be avoided unless doing so is detailed in the installation manual.
If a suppression ferrite is attached to a cable, this ferrite should not be removed. If the ferrite
needs to be removed during installation it must be reassembled in the same position.
Suppression Ferrites
Connections to Other Equipment
If your Raymarine equipment is to be connected to other equipment using a cable not supplied
by Raymarine, a suppression ferrite MUST always be attached to the cable near to the
Raymarine unit.
offered by Busse-Yachtshop.com
The illustration shows typical cable suppression
ferrites used with Raymarine equipment. Always
use the ferrites supplied by Raymarine.
D6626-1
-7