Controlling The Transfer Charging Roller Bias - Canon imageRUNNER 330 Service Manual

Hide thumbs Also See for imageRUNNER 330:
Table of Contents

Advertisement

CHAPTER 6 IMAGE FORMATION SYSTEM
D. Controlling the Transfer Charging Roller Bias
1. Outline
The machine uses a charging roller for direct transfer. A DC bias is applied to the transfer
charging roller, and the mechanism is controlled for the following:
• DC bias constant voltage/constant current
• Application voltage level (correction; ATVC control)
• Output by operation mode
• Output by humidity sensor reading
AC power supply voltage input
Transfer charging output
enable signal(HVTEN*)
J103B
J209B
Constant voltage/constant current
switch signal(HVTSEL*)
J103B
J209B
Transfer output mode signal 1(HVTM2*)
J103B
J209B
Transfer output mode signal 2(HVTM1*)
J103B
J209B
Transfer output mode signal 3(HVTM0*)
J103B
J209B
Serial communication
Transfer bias ON signal
Transfer bias level signal
J103A
J209A
6-8
COPYRIGHT © 1999 CANON INC. CANON imageRUNNER 400/330 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
Composite power supply PCB
Transformer
High-voltage
drive signal
main transformer
Cleaning bias output signal
Voltage value
(ATVC measurement value)
Transfer bias ON signal
Transfer bias control signal
Measurement value
Figure 6-105
Cleaning bias
Output
control
Voltage
detection
High-voltage
transformer for
transfer charging
Current
Drive
detection
control
Current value
Photosensitive
{
drum
Transfer bias
Transfer
charging roller
Humidity
detection

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Imagerunner 400

Table of Contents