Routing The Scanner Cable - Canon imageRUNNER 330 Service Manual

3. Routing the Scanner Cable

Caution:
You will need the following tools for routing the scanner cable:
1. Mirror mounting tool (FY9-3009-040)
2. Pulley clock (FY9-3037-000)
Perform the following in the order indicated:
1) Put the steel ball into the hole in the pulley [1]; then, wind the cable 4.5 times inward and 3.5
times outward (both front and rear).
2) Secure the cable in place with the pulley clip.
3) Fit the mirror positioning tool [2].
4) Fit the cable as shown [3] [4] [5] [6].
5) Loosen the set screw (font only) of the drive pulley and then tighten it so that the tension is
even throughout [7].
6) Secure the No. 1 mirror mount and the scanner cable metal fixing in place temporarily [8].
7) Secure the cable spring stay so that the length of the spring is 38 to 39 mm [9].
[2]
Fit the mirror
positioning tool.
[9]
38~39mm
COPYRIGHT © 1999 CANON INC. CANON imageRUNNER 400/330 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
Loosen the set
screws to free
the pulley.
Set
screws
[7]
Put the steel ball
into the hole of the
pulley, and wind it
four times inward
and three times
outward; then,
fit the pulley clip.
Steel ball
[8]
[5]
[6]
Figure 3-512
CHAPTER 3 EXPOSURE SYSTEM
Pulley clip
[4]
[2]
[3]
[1]
3-15