Position The Reflective Sensor - Brady THT MVPplus Quick Reference Manual

Bradyprinter THT MVPplus Quick Reference Guide

Position the Reflective Sensor

Position the Reflective Sensor
Note • This sensor is typically covered by a factory-installed plate. If you need to enable this
sensor, you must remove the plate.
Refer to
Open the printhead assembly and turn on the AC power.
1.
Locate the reflective sensor positioning lever.
2.
For non-continuous media: Move the lever across the width of the media to align the
3.
reflective sensor with the start-of-label indicator (notch, hole, black mark, or gap). The
glow of the red LED through the media helps to position the sensor.
For continuous media: Position the reflective sensor anywhere under the media so that a
4.
"MEDIA OUT" condition can be sensed.
5. Ensure that the media and ribbon are properly positioned.
Close the printhead assembly.
6.
EN-8
Figure 6.
Figure 6 • Position the Reflective Sensor
13293LB-12 Rev. 2 16Nov2004
Printhead
Transmissive
Sensor
Reflective
Sensor
Reflective Sensor
Positioning Lever
English