Table of Contents
Advertisement
Bradyprinter THT MVPplus Quick Reference Guide
Configure the Printer
Configure the Printer
The configuration procedure in the next table contains the information you need to get your
printer up and running, but it is not comprehensive. Refer to the user guide for more
information.
To enter Configuration Mode, press SETUP/EXIT at the
Note •
You will need to press (+) more than once to advance to some of the displays.
Remember:
• Press SELECT once to use (+) and (–) to change the value of the selection.
• Press (+) to scroll to the next selection, increase the value, answer "yes," or print a label
(when applicable).
• Press (–) to return to the previous selection, decrease the value, select the digit you wish to
change, or answer "no."
• Press SELECT again to use (+) and (–) to scroll to the desired menu item.
Menu Display
DARKNESS
PRINT MODE
MEDIA TYPE
SENSOR TYPE
SENSOR SELECT
PRINT METHOD
SAVE CHANGES
PRINTER READY
EN-12
Table 4 • Configure the Printer
Description
0 to 30 (default setting is 10)
Tear-Off, Peel-Off, Cutter, Rewind (default setting is
Tear-Off)
Non-continuous, continuous (default setting is non-
continuous)
Web, mark (default setting is web)
Auto Select, Reflective, Transmissive (default is
Transmissive)
Thermal transfer, direct thermal (default setting is thermal
transfer)
Permanent, temporary, cancel, load defaults, load last saved
(default setting is permanent)
You have exited Configuration Mode and are ready to print a
test label.
13293LB-12 Rev. 2 16Nov2004
PRINTER READY
display.
English
Advertisement
Table of Contents
