HYOSUNG RT125D Owner's Manual page 56

● ● FRONT BRAKE FLUID SUPPLY
1. Place the motorcycle on a level surface
and keep the handlebars straight.
2. Clean the brake fluid reservior around not
to allow dust to get inside of it.
3. Loosen the screw and open the cap.
4. Replenish with brake fluid to the upper
line.
CAUTION
Do not spill any brake fluid on painted or
plastic surfaces as it will damage the
surface severely.
N O T E
The recommended brake fluid
5. Fasten the cap.
● ● FRONT BRAKE LAMP SWITCH
The front brake lamp switch is located
beneath the front brake lever. Loosen the
switch fitting screws and adjust the timing by
moving the switch body forward or
backward.
: DOT3 or DOT4
55
◉ ◉ REAR BRAKE
● ● REAR BRAKE ADJUSTMENT
WARNING
Too much clearance in the rear brake
pedal can cause poor braking
performance and may lead to an
accident. Too little clearance may force
brake shoes to rub against the drum at
all times, causing damage to the shoes
and the drum.
Follow the steps in this section to adjust
the rear brake pedal properly.
Adjust the free travel
(0.79 ~ 1.18 in) by screwing in or out the
brake adjusting nut
�
�
①
to 20 ~ 30 mm
②
.
�