HYOSUNG RT125D Owner's Manual page 38

★ ★ BREAKING IN THE NEW TIRES
New tires need proper break-in to assure
maximum performance, just as the engine
does.
Wear in the tread surface by gradually
increasing your cornering lean angles over
the first 160km (100miles) before
attempting maximum performance. Avoid
hard acceleration, hard cornering, and hard
braking for the first 160km (100miles).
WARNING
Failure to perform break-in of the tires
could cause tire slip and loss of control.
Use extra care when riding on new tire.
Perform proper break-in of the tire as
described in this section and avoid hard
acceleration, hard cornering, and hard
braking for the first 160km (100miles).
★ ★ ALLOW THE ENGINE OIL TO
CIRCULATE BEFORE RIDING
Allow sufficient idling time after warm or
cold engine start up before applying load or
reviving the engine. This allows time for the
lubricating oil to reach all critical engine
components.
★ ★ OBSERVE YOUR FIRST, AND
MOST 1,000 ㎞ ㎞
The 1,000km (600miles) service is the
most important service your motorcycle will
receive.
During break-in procedures all of the
engine components will have worn in and
all of the other parts will have seated in.
All adjustments will be restored, all
fasteners will be tightened, and the dirty
engine oil and engine oil filter will be
replaced.
SERVICE
Timely performance of the 1,000km
(600miles) service will ensure optimum
service life and performance from the
engine.
Service should may be peformed before
1,000km (600miles) on motorcycle that
are used under severe conditions.
The 1,000km (600miles) service should
be performed as outlined in the
INSPECTION AND MAINTENANCE
section of this Owner's Manual. Pay
particular attention to the 『 『 CAUTION』 』
and 『 『 WARNING』 』 in that section.
37
CAUTION
CAUTION