HYOSUNG RT125D Owner's Manual page 46

◉ ◉ CLEAN OF BATTERY TERMINAL
Clean the battery terminal when it is dusty
or rusted.
1. Set the ignition switch "OFF" position.
2. Remove the right side cover, disconnect
the negative (-) battery wire first, then
disconnect the positive (+) battery wire.
Remove the battery.
3. Clean the terminal.
If there is white dust, clean it with warm
water.
4. Connect the battery wires and grease
the terminal lightly.
When reinstalling the battery, be sure to
connect the positive (+) battery wire
first, then connect the negative (- )
battery wire.
● ● Hydrogen gas produced by
batteries can be hazardous.
Batteries produce flammable
hydrogen gas which can explode if
exposed to flames or sparks.
● ● Keep the battery away from fires or
sparks.
Never smoke when working near
the battery.
● ● When disconnecting the battery
wire, be sure to remove the
negative (-) battery wire first with
the ignition switch "OFF" position,
then remove the positive ( + )
battery wire.
When reinstalling the battery, be
sure to connect the positive ( + )
battery wire first, then connect the
negative (-) battery wire.
● ● Fasten certainly the battery wires.
● ● Reversing the battery lead wires
can harm your motorcycle.
Reversing the battery lead wires
can damage the charging system
and battery.
The red lead must go to the
positive ( + ) terminal and the black
(or black with white tracer) lead
must go to the negative (- )
terminal.
● ● Never charge a battery while still in
the machine as damage may result
to the battery or regulator / rectifier.
45
CAUTION