Outside Line Types; Transmission, Network, And Control Specifications; Network - NEC Electra Elite 192 Hardware Manual

Issue 6
2 - 10
4.4

Outside Line Types

The following outside lines can be used with the Electra Elite 192
system.
2-wire, Loop Start or Ground Start Trunks
¥
2-wire, 2-way DID Lines (Dial Pulse or DTMF)
¥
4-wire, E&M Tie Lines (Type I or V, Dial Pulse, or DTMF)
¥
Digital Trunk FT1 (Loop Start, Ground Start, Tie Line (E&M), or
¥
DID Signaling)
ISDN-BRI Trunks
¥
ISDN-PRI Trunks
¥
VoIP Trunks (Internet Protocols)
¥
Refer to Table 1 FIC, REN, SOC, and Jack Types for Electra Elite
System ETUs
for a detailed list of Facility Interface Codes, Ringer Equivalence
Numbers, Service Order Codes and Jack Types.
4.5

Transmission, Network, and Control Specifications

4.5.1 Transmission
¥
¥
¥
4.5.2

Network

Time Division Multiplexing allows transmission of a
number
simultaneously over one communications medium. The
information below indicates the specifications the Electra
Elite 192 system uses for switching, clock, data bus,
timeframe.
¥
¥
in the Regulatory Information section in this manual
Data Length
From Multiline Terminal to ESI(8)-U10 ETU: 23 bits
From ESI(8)-U10 ETU to Multiline Terminal: 23 bits
Data Transmission Rates:
Between ESI(8)-U10 ETU and Multiline Terminal:
184K bps (voice and signaling)
Scanning Time for each Multiline Terminal: 32 ms.
of separate
TDM Switching: PCM (µ Law)
TDM Clock: 2.048 MHz
Electra Elite
data, voice and/or
System Specifications
video