Alarm - G Sensor Settings - EverFocus EMS200S User Manual

5.3.4 Alarm – G Sensor Settings
G-Sensor: Select On to enable the G-Sensor event function. Select Off to disable the G-Sensor event function.
XY Axial Trigger Value: Set the XY Axial trigger value. If the setting above is ON, the alarm will be triggered
when acceleration reaches this value in a horizontal direction with respect to the horizon.
Z Axial Trigger Value: Set Z Axial trigger value, alarm will be triggered when acceleration reaches this value in
vertical direction with respect to the horizon.
Alarm Output: This will transmit a signal through the alarm output relay. It can be set to either "NONE" (not
active), "1" (active) or "2" (active).
Output Type: Output action when alarm is triggered.
Timeout: Alarm output lasts for the set time duration.
Permanent: Alarm will be continuously active until user presses the "Enter" key.
Transparent: Alarm output remains active until event ends.
Trans+Timeout: Alarm output continues until event ends, then lasts for the set time duration.
Timeout Duration: The amount of time the alarm output will be active when GPS is lost. Duration selectable from
1 to 150 seconds.
Pre-alarm Record: Check this box to start copying recorded video to the storage device from 5 seconds before
the video loss. (Pre-alarm recording rate will follow the "Normal" frame rate setting)
Email Notify: Check this box to enable email notification when GPS is lost. Email operation requires that valid
email settings have been entered in the Network Setting/Email setup screen.
Network Alarm: Check this box to send out a network alarm to client PC. (Requires CMS software, including
EverFocus' PowerCon or PowerVideo Plus, and setting up Alarm Server in Network Setup menu.)
Click button to return to the previous level of menu.
Alarm – G-Sensor Settings menu
36